| Last Modified: 11-29-2007 | 1.6 J | |
| Service Category: Steering | Section: Steering Column | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000000XZD01FX |
| Title: STEERING COLUMN: POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM: DESCRIPTION (2008 Sequoia) | ||
|
Actuator Power Source Circuit |
DESCRIPTION
This is the power source for the motors.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
|
1. |
INSPECT FUSE (TI & TE) |
|
(a) Remove the TI & TE fuse from the main body ECU. |
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
TI & TE fuse |
Always |
Below 1 Ω |
|
|
2. |
CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY) |
|
(a) Disconnect the H57 multiplex tilt and telescopic ECU connector. |
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
H57-2 (+B) - Body ground |
Always |
11 to 14 V |
|
|
3. |
CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND) |
|
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
|
|